Upgraded Talaria 220mm Brake Rotor

Upgraded 220mm x 2.3mm Brake Rotor for Talaria XXX MX3 MX4

Engineered with a flame pattern to increase airflow and heat dissipation. 2.3mm Thickness allows use of stock calipers, MTB calipers, or Moto Brake Calipers.

• Made From 12CR13 Stainless Steel
• Fits: Talaria XXX, MX3, MX4
• 220mm Diameter for increased braking power
• 2.3mm thickness for maximum heat dissipation and compatibility across many kinds of brake calipers
• Rear Bolt Pattern for Talaria Rotor ( 68mm )
• Front Bolt Pattern for Talaria, or most Emoto front rotors ( 44mm )

Install Steps:

1. Remove your wheel
2. Lightly heat your bolts holding on the stock rotor ( to break the locktite loose )
3. Remove your stock rotor bolts, then slip the rotor off
4. Apply a thin layer of Blue Locktite ( or similar thread locker )
5. Slip on the new rotor and tighten the bolts down by hand
6. Use a torque wrench to torque each bolt to desired spec
7. Re-install your wheel
8. DO NOT FORGET to install new Brake Pads & Slowly Bed in your new pads and rotor!

FAQ:

Q: Does this fit the Talaria MX5?
A: No this rotor is only made to fit the Talaria XXX, MX3, MX4

Q: Does this rotor work with FactoryZ Moto Brakes?
A: No our moto brake bracket is made to use our 240MM Rotors, running a 220 rotor will cause the pads to not have enough contact.

Ships from USA!